xtc file format

Main Table of Contents VERSION 5.0.7


The xtc format is a portable format for trajectories. It uses the xdr routines for writing and reading data which was created for the Unix NFS system. The trajectories are written using a reduced precision algorithm which works in the following way: the coordinates (in nm) are multiplied by a scale factor, typically 1000, so that you have coordinates in pm. These are rounded to integer values. Then several other tricks are performed, for instance making use of the fact that atoms close in sequence are usually close in space too (e.g. a water molecule). To this end, the xdr library is extended with a special routine to write 3-D float coordinates.

All the data is stored using calls to xdr routines.

int magic
A magic number, for the current file version its value is 1995.
int natoms
The number of atoms in the trajectory.
int step
The simulation step.
float time
The simulation time.
float box[3][3]
The computational box which is stored as a set of three basis vectors, to allow for triclinic PBC. For a rectangular box the box edges are stored on the diagonal of the matrix.
3dfcoord x[natoms]
The coordinates themselves stored in reduced precision. Please note that when the number of atoms is smaller than 9 no reduced precision is used.

Using xtc in your "C" programs

To read and write these files the following "C" routines are available:
/* All functions return 1 if successful, 0 otherwise */  

extern int open_xtc(XDR *xd,char *filename,char *mode);
/* Open a file for xdr I/O */
extern void close_xtc(XDR *xd);
/* Close the file for xdr I/O */
extern int read_first_xtc(XDR *xd,char *filename,
			  int *natoms,int *step,real *time,
			  matrix box,rvec **x,real *prec);
/* Open xtc file, read xtc file first time, allocate memory for x */

extern int read_next_xtc(XDR *xd,
			 int *natoms,int *step,real *time,
			 matrix box,rvec *x,real *prec);
/* Read subsequent frames */

extern int write_xtc(XDR *xd,
		     int natoms,int step,real time,
		     matrix box,rvec *x,real prec);
/* Write a frame to xtc file */
To use the library function include "gromacs/fileio/xtcio.h" in your file and link with -lgmx.$(CPU)

Using xtc in your FORTRAN programs

To read and write these in a FORTRAN program use the calls to readxtc and writextc as in the following sample program which reads and xtc file and copies it to a new one:
      program testxtc
      parameter (maxatom=10000,maxx=3*maxatom)
      integer xd,xd2,natoms,step,ret,i
      real    time,box(9),x(maxx)
      call xdrfopen(xd,"test.xtc","r",ret)
      print *,'opened test.xtc, ret=',ret
      call xdrfopen(xd2,"testout.xtc","w",ret)
      print *,'opened testout.xtc, ret=',ret
 10   call readxtc(xd,natoms,step,time,box,x,prec,ret)
      if ( ret .eq. 1 ) then
         call writextc(xd2,natoms,step,time,box,x,prec,ret)
         print *,'Error reading xtc'
To link your program use -L$(GMXHOME)/lib/$(CPU) -lxtcf on your linker command line. The source for this test can be found in file $(GMXHOME)/src/gmxlib/testxtcf.f.